M35A2 Hood Handle Kit
If you are tired of fighting to get the hood open on your M35A2 Deuce and a half or just tired of tearing up your finger tips we have the solution! The M35A2 hood handle kit!
Based on the design from the old PS Magazine article these are now readily available. Our hood handle is a simple 15 minute installation requiring just two additional holes in the hood and basic hand tools.
This handle features a slightly wider design to accommodate even the largest of gloved hands. The 1/8" thick backing plate is 7" x 2" to spread the load out on the sheet metal and avoid stress cracks.
A simple addition that should have been original equipment on every Deuce and a half.
Note: Since everyone has their own preference for paint color we are supplying these in the raw with plated hardware.
Reviewed by: Frank 10/24/2022 06:46PM
Product ownership: Less than 3 months
Purchased from: Rattlin' Truck & Tractor
Hands down the best addition I've made to my deuce so far. Perfect fit and looks good!
You must login to post a review.